Our first branded hardware!

Over the past nine months or so, we’ve been able to show Museum in a Box to hundreds of people, either in our office or at events, and the response has been fantastic.

It’s also been ongoing informal user research, and we’ve had the chance to watch people figure out how to use it. We’ve varied our description of the mechanics and amount of setup, and observed (very casually) little sticking points. One of the main things we noticed is that it wasn’t clear when the Brain was ready to go. The Raspberry Pi 2 takes a while to start up and get ready to read an object, about 30 seconds, actually. So, we’ve added a physical progress bar to the box to help people know when it’s ready. It even says READY!

Adrian soldered the first version, which you can see here. We also adjusted the layout of the box to simplify it a bit. All you really need to know about is power, volume and when it’s ready.

2016-06-08 10.35.162016-06-08 10.35.25-1

And we put a BIG GREEN LIGHT at the end, which is fun.

2016-06-08 13.41.05-1

I’ve also been thinking about what kind of simple instructions we’ll need to include in a box that doesn’t have us driving it. Hopefully something like this, with just three steps would be good.

2016-06-17 14.57.28

And then, Adrian took a very exciting step and ordered us our very own Printed Circuit Board (PCB) to drive the progress bar from now on.

2016-07-08 20.26.49

2016-07-15 16.32.09

It’s possible I’m overexcited about the progress bar, but, I love it!

Leave a Reply

Your email address will not be published. Required fields are marked *